Difference between revisions of "Synchronisation and Cyclic Prefix Handling For LTE Testbed"
|Line 33:||Line 33:|
Revision as of 16:43, 9 December 2015
By the end of the decade billions so called Internet-of-Things (IoT) devices will be connected to the Internet. IoT nodes can range from electrical energy meters to tiny positioning nodes connected to a cellular network. In particular the latter require low power consumption and low footprint. To this end, the 3GPP standardization committee specified a new user equipment category (Cat-0) for low complexity IoT devices in release 12 . The low complexity is achieved by single receive antenna and 1.4 MHz bandwidth requirements. A further bandwidth reduction down to 200 kHz may be considered for release 13 .
In this project, the base for the development for an LTE release 12 and release 13 based IoT module shall be established. A commercially available LTE RF transceiver can be used to extract baseband I/Q samples onto an FPGA testbed. Preliminary synchronization as well as FFT computation shall be implemented and tested.
Status: In Progress
 3GPP. Release 12. http://www.3gpp.org/release-12, 2015.
 3GPP. Release 13. http://www.3gpp.org/release-13, 2016.